|
|
Post by fast44 on Jul 26, 2009 22:58:21 GMT -5
I was wondering if anybody is else is having this problem. My inner rear wheels keep on stripping out. Im just wondering if there is a solution.
|
|
|
|
Post by Steve on Jul 26, 2009 23:42:45 GMT -5
Get some wheels that uses hexes instead vs. the Pin and Wheel design.
|
|
|
|
Post by Rob #28 on Jul 27, 2009 7:04:11 GMT -5
Sounds like the wheel nut is not tight enough. Its the same setup they have ran on the buggies and trucks for over 20 years now without any issues, so it should work fine on this truck.
|
|
|
|
Post by Steve on Jul 27, 2009 11:12:00 GMT -5
I have heard of this problem being really common on the SC10 truck, not sure why here and not the other trucks like B4 / T4. I'd still recoomend hex wheels.
|
|
|
|
Post by slasherfred on Jul 27, 2009 14:06:24 GMT -5
|
|
|
|
Post by fast44 on Jul 27, 2009 16:03:38 GMT -5
ok thanks i already heard of doing that i just didnt want to spend alot of money.
|
|
|
|
Post by slashracer88 on Jul 28, 2009 9:13:05 GMT -5
they could have had a problem with the plastic not setting up right in the molds. ive gone thru 3 sets or rears. two lefts and a right.
|
|
|
|
Post by SamHill on Jul 28, 2009 16:38:36 GMT -5
People have been JB Welding in the little pie shapes between the pins and that seems to be holding up.  |
|
|
|
Post by fast44 on Jul 28, 2009 16:50:17 GMT -5
ok thanks
|
|
